Continuous Fence Installation in Central Kansas

Continuous fence is pre-welded steel panel — typically four to six horizontal pipe or rolled-steel rails in roughly 20-foot sections — bolted together and run on solid posts. There's no wire to stretch and no boards to replace, which is why ranchers use it for corrals and high-pressure areas where ordinary fence gives out.

A properly set continuous fence easily lasts 30 years or more out here. The steel doesn't rot or warp, and the only real upkeep is a coat of paint or primer down the road. The posts are what matter — set deep in concrete the way we do it, the run stays plumb through years of freeze-thaw and wind.

For corrals, pens, and high-traffic corners, yes. Barbed wire sags and snaps where cattle crowd it, while welded continuous panel spreads that pressure across several posts and holds. The smooth steel is also easier on hides. Barbed wire still has its place on long, low-pressure pasture lines where budget matters more — we'll tell you honestly which fits your spot.

It's excellent for horses and cattle. Standard rail spacing is too wide to hold goats, sheep, or young calves on its own, but we can tighten the spacing or add a bottom run of wire or panel so smaller stock stay contained. Tell Cody what you're running and we'll spec it right.

Most installed continuous fence runs about $14–$30 per linear foot here, depending on the number of rails, pipe weight, gates, and how rough the ground is. Straight perimeter is on the lower end; tight corrals and heavy pipe push higher. A free on-site estimate is the only way to get a real, written number.

Absolutely. We weld and connect continuous panel into pipe posts, existing corrals, and ranch entry gates all the time, so your new run matches what's already there. If you want a full steel setup — pipe posts, continuous panel, and a matching entry gate — we build the whole thing as one clean job.